Dacă afișajul electronic LED este folosit în aer liber, acesta se va confrunta cu multe provocări. Ecranul de afișare cu LED va fi afectat de vreme severă, cum ar fi temperatură ridicată, val de frig, vânt puternic, ploaie etc. Dacă aceste aspecte nu sunt făcute bine, funcționarea în siguranță a ecranului va fi imposibil de discutat. Astăzi, vă voi spune cum să instalați afișajul electronic LED pentru a preveni scurgerile de apă.
1. Adăugați placa de bază pentru a sigila lipici
In order to save trouble, many friends install outdoor LED displays without backplane or backplane without sealant. Over time, the electronic components will be flooded, and LED displays will have problems over time. The most feared thing for electronic components is water. Once water enters the circuit, it will cause the circuit to burn out. These problems that can be solved at hand must not be ignored.
În al doilea rând, lovește scurgerea
If the LED electronic display and the back panel are tightly integrated, a water leak must be made below; the so-called water leak is used for water leakage. No matter how tight the front and back of the LED display are combined, there will be more or less water inside the LED display over the years. If there is no leaking hole in the lower mouth, the water will accumulate more and more over time. If the leaking hole is punched, the water will be If it flows away, it can have a good waterproof effect, and it is also good for prolonging the service life of the LED display.
Trei, linia potrivită
When installing the LED electronic display, you must use the appropriate wire for the plug connection. Generally, the principle of n Small wires, it is easy to cause the circuit to burn out, thereby affecting the safe operation of the LED display.
